Maintenance And Care; Precautions And Tips - Indesit LI7 Serie Gebrauchsanleitungen

Your food will be safe until the liquids are as shown below.
If one or both of the liquids are dissolved, this is an indication of
increased temperature in the freezer.
Even the partial melting of one of the two liquids can show an
abnormal increase of the internal temperature.
If the liquid A1 melts, food must be eaten in a week.
If the liquid A2 melts, food should be thrown away.
• Do not leave the door open for a long period of time. Close
the door of the freezer since the blackout sensor detector can
give the wrong alarm. Load or unload the freezer as quickly
as possible to avoid interventions of the black-out detector
sensor. Leaving the door open for a long period of time, the
liquid can dissolve on the black-out detector sensor, but the
food in the freezer can be still in good condition.
• Check the state of the liquid only in the presence of electricity.
The freezer is able to maintain the frozen food properly for xx
hours (depending on the outside temperature) in the case of
black-out. If the refrigerator is in a condition of black-out for a
shorter period, it is recommended not to open the doors and
wait.
• Place the hot food on the back of the freezer compartment.
The hot food that is close to the detector blackout sensor may
dissolve liquids and cause ill-timed interventions.

Maintenance and care

Switching the appliance off
During cleaning and maintenance it is necessary to disconnect
the appliance from the electricity supply.
It is not sufficient to set the temperature adjustment knobs on
(appliance off) to eliminate all electrical contact.
Cleaning the appliance
• The external and internal parts, as well as the rubber seals may
be cleaned using a sponge that has been soaked in lukewarm
water and bicarbonate of soda or neutral soap. Do not use
solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in warm water and
soap or dishwashing liquid. Rinse and dry them carefully.
• The back of the appliance may collect dust which can be
removed by delicately using the hose of a vacuum cleaner set
on medium power. The appliance must be switched off and
the plug must be pulled out before cleaning the appliance.
All manuals and user guides at all-guides.com
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic materials which
are odour free. In order to maintain an odour free refrigerator
and to prevent the formation of stains, food must always be
covered or sealed properly.
• If you want to switch the appliance off for an extended period
of time, clean the inside and leave the doors open.
Replace LED * light
The LED lighting, thanks to the powerful diffused light, allowes
a clear view of each food. If you need to replace the LED light,
contact theTechnical Service.
Replacing the light bulb *
To replace the light bulb in the refrigerator compartment, pull out
the plug from the electrical socket. Follow the instructions below.
Access the light bulb by removing the cover as indicated in the
diagram. Replace it with a similar light bulb within the power range
indicated on the cover.

Precautions and tips

! The appliance was designed and manufactured in compliance
with international safety standards. The following warnings are
provided for safety reasons and must be read carefully.
This appliance complies with the following Community Directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent
amendments;
-89/336/EEC of 03.05.89 (Electromagnetic Compatibility) and
subsequent amendments;
- 2002/96/CE.
General safety
• The appliance was designed for domestic use inside the home
and is not intended for commercial or industrial use.
• The appliance must be used to store and freeze food products
by adults only and according to the instructions in this manual.
• The appliance must not be installed outdoors, even in covered
areas. It is extremely dangerous to leave the appliance
exposed to rain and storms.
• Do not touch the appliance with bare feet or with wet or moist
hands and feet.
• Do not touch the internal cooling elements: this could cause
skin abrasions or frost/freezer burns.
*
Varies by number and/or position, available only on certain
models.
GB
3
17