Electrical Connection; Changing Over The Door Hinges - Bosch KGS Serie Aufstell- Und Umbau-Anweisung

en de

Electrical connection

S Connect the appliance only to a
220 240 V alternating current (50 Hz,
10 amp fuse) via a correctly installed
earthed socket.
Changing over the door
hinges
We recommend that our customer service
changes over the door hinges.
Before you begin the conversion, pull out
the mains plug or remove the fuse.
Never pull out the mains plug by tugging
the cable!
Fig. 2
S Remove the base rim (5). To do this,
pull outwards and then forwards first
on the left side and then on the right
side. Insert stopper (6) on the opposite
side of the base rim.
S Unscrew the pin (8) out of the lower
hinge (7) (open end wrench A/F 8).
Remove bearing bush and spacer ring
and keep in a safe place! Remove
freezer compartment door (1).
S Unscrew the middle hinge (9) and
remove the refrigerator door (2).
S Take the two plastic stoppers (10) out
of the opposite side and insert into the
installation openings in which the
middle hinge (9) had been screwed.
S Unscrew the upper retention pin
(11)and screw onto the opposite side.
6
S Place the refrigerator door (2) on
the upper retention pin (11) and screw
on the middle hinge (9).
Do not forget to add washers for
precision adjustment of the refrigerator
door (2) and middle hinge (9).
S Place the freezer compartment door (1)
on the pin of the middle hinge (9).
Put the bearing bush and spacer ring on
the lower stop (7). Screw in and tighten
the pin (8) (open end wrench A/F 8).
S Attach the base rim (5).
S Remove plastic stoppers and fastening
screws (4) from the handle.
Push the handle (3) horizontally to the
left and then pull out. Insert the handle
on the other side by implementing
the previously described procedure in
reverse sequence. Insert the plastic
caps into the open boreholes.
Warning!
Before switching on the refrigerator again,
leave it to stand for two hours without
moving it.