Power Switch - Peavey Ecoustic Serie Bedienungsanleitung

E110 Rear Panel

POWER SWITCH

14
To apply power to the unit, flip the switch to the "On" position.
Caution: The Power switch in this unit does not break both sides of the primary mains.
Hazardous energy can be present inside the chassis even when the Power switch is in the
OFF position.
AC POWER INLET
15
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line voltage
is used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does
not have a ground pin, a suitable grounding adapter should be used, and the third wire should be
grounded properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and all
associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark-
ings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yel-
low must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored
green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is
marked with the letter N, or the color black. (3) The wire that is colored brown must be connected to the
terminal that is marked with the letter L, or the color red.
REMOTE SWITCH JACK
16
For plugging in the Ecoustic Series foot controller (Peavey part number 03582670) . The Ecoustic
Series foot controller is sold separately and is described in detail on page 23.
DI OUTPUT WITH GROUND LIFT
17
Studio-quality XLR Direct Interface with ground lift switch. Usually this should be left in the 'out' posi-
tion however there may be certain situations when connecting from the DI socket(s) to another
device that a hum is produced due to a ground loop. If this happens then pressing the Ground Lift
switch in should eliminate the problem.
15