Compliance Information - DJI OSMO ACTION Sicherheitsvorschriften

Compliance Information

FCC Compliance Notice
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) This device must accept
any interference received, including
interference that may cause undesired
operation.
Any changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate the
equipment.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving
antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced
radio/TV technician for help.
84
RF Exposure Information
This equipment complies with FCC
radiation exposure limits set forth for
an uncontrolled environment. In order
to avoid the possibility of exceeding
the FCC radio frequency exposure
limits, End user must follow the specific
operating instructions for satisfying RF
exposure compliance. This transmitter
must not be co-located or operating in
conjunction with any other antenna or
transmitter.
ISED Warning
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada's licence-exempt
RSS(s). Operation is subject to the
following two conditions: (1)This device
may not cause interference.(2)This
device must accept any interference,
including interference that may cause
undesired operation of the device.
L'émetteur/récepteur exempt de licence
contenu dans le présent appareil
est conforme aux CNR d'Innovation,
Sciences et Développement
économique Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux
conditions suivantes :(1)L'appareil
ne doit pas produire de brouillage;
(2)L'appareil doit accepter tout
brouillage radioélectrique subi, même
si le brouillage est susceptible d'en
compromettre le fonctionnement.
This equipment complies with ISED
radiation exposure limits set forth for
an uncontrolled environment. End
user must follow the specific operating
instructions for satisfying RF exposure
compliance. This transmitter must
not be co-located or operating in
conjunction with any other antenna
or transmitter.The portable device is
designed to meet the requirements for
exposure to radio waves established by