Assembly - Husqvarna WDC 220 Bedienungsanweisung

Dangerous materials
WARNING: Do not clean dangerous
materials. This can cause injuries.
• Do not clean the following materials:
• dangerous dust
• hot materials, for example burning cigarettes and
hot ash.
• flammable, explosive, aggressive liquids, for
example gasoline, solvents, acids and alkalis.
• flammable, explosive dust, for example
magnesium or aluminum dust.
Spare parts and accessories
CAUTION: Only use spare parts and
accessories for the safety of the product.
• Use only spare parts and accessories from
Husqvarna.
• Use only the brushes supplied with the product or
referred to in the operator's manual.
Explosive or flammable atmosphere
CAUTION: Do not use the product in
explosive or flammable atmospheres. Do not
use the product near liquids, gas or fume
that can cause flammable atmospheres.
WARNING: Read and understand the safety
chapter before you assemble the product.
To do before installation
1. Unlock the clasps and lift off the motor unit. (Fig. 8)
2. Remove the accessories from the dirt container.
(Fig. 9)
3. Make sure that all parts are included. See the
product overview. Necessary tools: Screwdriver.
To install the filter bag
1. Put the main switch to the "0" position.
2. Disconnect the product. (Fig. 10)
3. Unlock the clasps and lift off the motor unit. (Fig. 8)
4. Put the filter bag in the dirt container.
5. Attach the cardboard part of the filter bag on the
vacuum inlet. Make sure that the rubber membrane
is passing past the heightening of the vacuum inlet.
(Fig. 11)
12
Blower function
WARNING: Dust can cause health
problems.The product has a blower function.
Do not blow the outgoing air randomly in
closed areas. Use the blower function only
with a clean hose.
Safety instructions for maintenance
WARNING: Read all warning instructions
that follow before you do maintenance on
the product.
To empty the dirt container
CAUTION: Cleaned material can be
dangerous to the environment. Discard the
dirt referring to legal regulations.

Assembly

6. Put the motor unit on the dirt container and lock the
clasps. (Fig. 12)
To attach the accessories
1. Put the accessories in their position for easy access.
(Fig. 13)
2. Attach the tool box at the rear of the product. (Fig.
14)
3. Attach the holder for the the cable and the hose at
the rear of the product. (Fig. 15)
To install the hose
1. Put the hose in the vacuum inlet on the front of the
product. (Fig. 16)
2. Connect the appliance into the mains.
3. Put the main switch to the "I" position. (Fig. 17)
4. Adjust the suction power on the handle or by the
main switch*. *Only on some models. (Fig. 18)
562 - 004 - 20.03.2019