Functional Description; Overview; Technical Specifi Cations; Notes On Safety - ULTIMATE SPEED UPM 120 A1 Originalbetriebsanleitung

Functional description

The device is designed for waxing and
polishing or dewaxing of vehicle varnish.
Rotating the polishing disc helps achieve a
consistent mode of operation. The polishing
bonnets can be exchange for different ap-
plications and detachable for cleaning.

Overview

1 Handle
2 ON / OFF switch
3 Polishing disc
4 2 Synthetic fur covers
5 2 Towelling covers
6 Mains cable
Technical specifi cations
Polishing machine ...... UPM 120 A1
Rated input voltage (U) .230-240 V~, 50 Hz
Power input (P) ........................... 120 W
Idling speed (n ) ......................3500 min
0
Safety class .....................................
Protection category......................... IP 20
Weight .................................. ca. 2.3 kg
Sound pressure
level (L ) ............... 61.7 dB(A); K
pA
Sound power level (L
measured .......... 72.7 dB(A); K
guaranteed ........................... 76 dB(A)
Vibration (a ) ...17.543 m/s
h
Levels of noise and vibration were determi-
ned according to the norms and regulations
in the declaration of conformity.
The vibration emission value has been mea-
sured according to a standardised testing
method and may be used for comparison
with another electric tool.
The indicated vibration emission value may
also be used for an introductory assessment
of the exposure.
= 3 dB
pA
)
WA
= 3 dB
WA
; K= 1.5 m/s
2
Warning: The vibration emission
value whilst actually using the elec-
trical tool may vary from the given
values independently of the type and
way in which the electric tool is used.
Safety measures for the protection of
the operator are to be determined
that are based on an estimate of the
actual exposure under the real ope-
rating conditions (for this, all parts of
the operating cycle are to be taken
into account, for example, times in
which the electric tool is turned off,
and those during which it is turned
on but running without a load).

Notes on safety

Caution! When using power tools,
observe the following basic safety
measures for the prevention of electric
shocks and the risk of injury and fi re.
Please read all these instructions be-
fore using this electric tool and please
-1
II keep the safety instructions.

Symbols and icons

Symbols on the device:
Warning!
Read the manual!
2
Remove the plug from the mains. Imme-
diately if the cable is damaged or cut.
Do not expose the unit to rain.
Wear eye protection
Wear breathing protection
Wear ear protection
GB
5