Extent Of The Delivery; Functional Description; Overview; Technical Specifications - ULTIMATE SPEED UPM 120 B3 Originalbetriebsanleitung

GB IE

Extent of the delivery

Carefully unpack the appliance and check
that it is complete. Dispose of the packag-
ing material correctly.
- Appliance
- 2 Towelling covers
- 2 Synthetic fur covers
- Instruction manual

Functional description

The device is designed for waxing and
polishing or dewaxing of vehicle varnish.
Rotating the polishing disc helps achieve a
consistent mode of operation. The polish-
ing bonnets can be exchange for different
applications and detachable for cleaning.

Overview

1 Handle
2 ON / OFF switch
3 Polishing disc
4 2 Synthetic fur covers
5 2 Towelling covers
6 Mains cable

Technical specifications

Electric polisher ...........UPM 120 B3
Rated input voltage
(U) ....................... 230-240 V~, 50 Hz
Power input (P) ............................ 120 W
Idling speed (n
) ......................3700 min
0
Safety class .....................................
Protection category...........................IPX0
Weight ........................... approx. 2.3 kg
Sound pressure level
(L ) ................... 61.7 dB(A); K
pA
16
Sound power level (L
measured .......... 72.7 dB(A); K
guaranteed ........................... 76 dB(A)
Vibration (a
Levels of noise and vibration were deter-
mined according to the norms and regula-
tions in the declaration of conformity.
- The specified total vibration values and
the stated noise emission values have
been measured according to a stand-
ardised test method and can be used to
compare one power tool with another.
- The specified total vibration values and
the stated specified noise emission val-
ues can also be used for a provisional
assessment of the load.
-1
II
= 3 dB
pA
)
WA
) .. 17.543 m/s
h
Warning:
The vibration and noise emissions
may deviate from the specified val-
ues during actual use of the power
tool, depending on the type and
manner in which the power tool is
used – and in particular which type
of workpiece is processed.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).
= 3 dB
WA
; K= 1.5 m/s
2 2