Symbols Used In This Document; General Information; Applications - Grundfos E-Box 500 Installations- Und Bedienungsanleitung

English (GB) Installation and operating instructions
Original installation and operating instructions
CONTENTS
1. Symbols used in this document
2. General information
2.1 Applications
2.2 Product overview
2.3 Symbols on the product
2.4 Nameplate
3. Installation
3.1 Installation kit
3.2 Electrical connection
3.3 Mechanical installation
4. Technical data
4.1 Dimensions
5. Cleaning
6. Disposal
Warning
Prior to installation, read these installation
and operating instructions. Installation and
operation must comply with local
regulations and accepted codes of good
practice.
Warning
Prior to installation, read the installation
and operating instructions of the relevant
CIM module and of the DDA dosing pump.
4

1. Symbols used in this document

Warning
Page
If these safety instructions are not
observed, it may result in personal injury.
4
4
If these safety instructions are not
4
Caution observed, it may result in malfunction or
5
damage to the equipment.
5
5 Notes or instructions that make the job
Note
easier and ensure safe operation.
5
5

2. General information

6
7

2.1 Applications

8
The Grundfos E-Box 500 (E-Box = Extension Box)
8
must only be used as a communication interface
8
between a SMART digital S DDA dosing pump and
an Ethernet network.
8
The E-Box 500 contains a CIM 500 module (CIM =
Communication Interface Module).
For internal communication between the E-Box and
the dosing pump, GENIbus is used.