Changing The Internal Light; Reversing The Door Swing - Candy COMBI Bedienungsanleitung

The drain hole will have a "cleaning spike" inserted into it. This ensures that small pieces off food
can not enter the drain. After you have cleaned the inside of your Fridge and removed any food
residues from around the whole, use the "cleaning spike" to make sure that there are no blockages.
Use standard furniture polish to clean the Fridge/Freezer exterior. Make sure that the doors are
closed to prevent polish getting on the magnetic door seal or inside.
The grille of the condenser at the back of the Fridge/Freezer and the adjacent components can be
vacuumed using a soft brush attachment.
Do not use harsh cleaners, scouring pads or solvents to clean any part of the Fridge/Freezer.

CHANGING THE INTERNAL LIGHT

1. Before carrying out the LED replacement always disconnect the mains supply.
2. Hold and lift up the LED light cover.
3. Remove the old LED by unscrewing it in an anti-clockwise direction.
4. Replace with a new LED light by screwing it in a clockwise direction marking sure that it is
secure in the light holder.
5. Refit the light cover and re-connect your Fridge to the mains supply and switch on.

REVERSING THE DOOR SWING

Dissemble the Refrigerator Door
1. a．Use a tool to remove the screw off the hinge cover, and then remove the latter. Insert the
communication line to the hole on the cabinet top.
b． Use a tool to remove the 4 screws off the upper hinge cover
and then remove the latter.
Pry up the door bush and small end cap cover on the door.
d． Use a tool to remove the 2 screws as shows in the below
figure to remove the hole cover on the cabinet top and get the
c． Insert the door bush and door communication line into the
hole on the door and then put on the small end cap cover.
46