Main Components - SOLAC CF4015 Gebrauchsanleitung

No liability will be accepted for damage caused by the use of the appliance for
other purposes, misuse or repairs by non-qualified personnel. Furthermore, the
guarantee does not cover the above cases.

MAIN COMPONENTS

1. Water tank cover.
2. Water tank.
3. Filter-holder.
4. Permanent filter.
5. Thermal cup.
6. Integrated thermal cup cover.
7. 1- or 2-cup selector.
8. On/off button with pilot light.
9. Digital Screen
10. Programme button.
11. Timer button.
12. Hour button.
13. Minutes button.
14. Ground coffee dispensing spoon.
15. No-spill watertight lids
INSTRUCTIONS FOR USE
MAKING THE COFFEE
• This coffee-maker lets you make one or two coffees at the same time in their
respective cups. First select 1 or 2 coffees using the selector (7) on the top of
the coffee-maker (Fig. 1). IMPORTANT! When you are going to make 1 cup,
use the left-hand side of the coffee-maker.
• Raise the water tank cover (1) and pour the water into the tank (2) (Fig. 2). Check
the maximum water level for 1 and 2 cups in the sight glass. Use the cup (5) to
fill the tank and calculate the desired amount of water per cup. If you are mak-
ing 2 cups, fill the tank with the sufficient amount (2 cups).
• Open the filter-holder (3) outwards by pulling the tab and make sure the perma-
nent filter (4) is correctly in position (Fig. 3). Then put the ground coffee in the
filter (4). Use the dispensing spoon (14) to calculate the amount of coffee. IMPOR-
TANT! The maximum recommended amount is three spoonfuls per cup. If you
put too much coffee in, it may spill during the brewing process.
• Close the filter-holder (4) and make sure it is correctly in position.
• Place both cups (5) with their cover (6) in the coffee-maker, even though you
are only going to make one cup, and plug the coffee-maker in.
10
Cafetera CF4015 10 12/7/05, 12:43:13