HP Designjet Z5200 Einführende Informationen Seite 8

Load a single sheet
Any loaded roll or sheet must be unloaded before loading a sheet.
For sheets thicker than 0.5 mm, you must have space behind the printer equal to the length of the sheet.
1. Standing in front of the printer, open the sheet tray.
If the tray is difficult to open, try opening from behind the printer.
2. Insert the sheet into the feeder. Load your sheet aligned with the load line and insert until the paper will not
continue, with thicker sheets you feel resistance. The printer detects the sheet in three seconds. A countdown
begins on the front-panel display.
Do not push your fingers inside the printer's paper path.
3. After the countdown, the paper feeds into the printer. Guide the sheet into the printer; this is especially important
with thicker papers.
4. The front-panel display asks if you are loading a roll or a sheet. Select
5. Select your paper category and type.
6. If you selected Sheet
Depending on the length of the sheet, it feeds out the front of the printer.
7 Introductory Information
in the Paper Load menu, the printer checks the alignment and measures the sheet.
Sheet with the Up and Down keys.