AEG DVD 4511 CR Bedienungsanleitung Seite 42

To clear 6-digit password if you forget your password,
follow the procedure below.
1. At the change page enter 6-digit number "136900"
(SUPERUSER PASSWORD) and then press
ENTER.
2. Enter a new password.
Last Memory
Press and to select LAST MEMORY.
• Press or to select ON or OFF, then press ENTER.
Default
To restore the original settings of the player, follow the
steps below.
Press and to select DEFAULT.
RESET will be highlighted. Press ENTER.
• The original settings of the player will be restored.
42
English.p65 42
Troubleshooting
Before calling customer service if you have problems with
this device, please search for the possible fault in the
table below. With a few simple tests or minor adjustments
you may be able to rectify the problem so that the device
functions correctly again.
Symptom (frequent) Remedy
No power insert the mains plug into the socket.
• No playback • Condensation has formed: wait
even if PLAY is approx. 1 to 2 hours until the device
pressed. has dried out.
• Playback begins • The device can only play back the
but stops again following media: DVDs, video CDs,
immediately. CDs, MP3s and JPEGs.
• The disc may be dirty and require
cleaning.
• Ensure that the disc has been
inserted with the label facing
upwards.
No picture. • Ensure that the device is properly
connected.
• Ensure that the television is turned
to "video"
• Please press the VIDEO button until
you have a picture again.
• No sound. • Ensure that the device is properly
connected.
• Distorted sound. • Ensure that the television and
stereo system have been adjusted
correctly.
• Adjust the main volume via the
remote control.
The picture is In this case the picture is sometimes
distorted during a little distorted – this is normal.
fast forward or
fast rewind.
No fast forward Some discs have sectors which do not
(or fast rewind) allow fast forward (or reverse)
playback. playback.
No 4:3 (16:9) Select the correct setting correspon-
picture. ding to the characteristics of you
television ("TV Aspects")
No Surround Select the correct setting under "Audio
Sound Output" corresponding to you stereo
system.
No operation • Check whether the batteries have
possible via the been inserted with the correct
remote control. polarity (+ and –).
• The batteries are flat and must be
replaced.
• Point the remote control in the
direction of the sensor on the
device.
• Do not use the remote control at a
distance of more than 5 metres
from the sensor.
• The remote control is adjusted to
the other key surface. Please press
the SHIFT button to change the key
surface.
9/5/05, 11:10 AM