Firmware Upgrade; How To Make An Update Disc - Samsung DVD-V6800S Anleitung

Firmware Upgrade

Please read the below information before
update procedure.
1
The following events may interrupt the update
procedure and may result in permanent
damage to DVD-VCR.
• Unplugging the power cord.
• Power outage.
• Dirt or Scratch in the discs.
• Open a tray door during processing.
2
Playback can only support English Subtitle.
If you have any question or any problem,
please feel free to contact your nearest
SAMSUNG Service Center and agency.
DivX Feature Table
• A DivX disc may not be playable as playback
depends on the file format, the recording
conditions, the recording method, etc.
• A video file that has not been interleaved
supports only voice or video.
• Check the DivX disc format as this is not an
error.
• Normal operation is only possible when the
screen size is 720X480 pixels or less.
• A maximum of 65 characters for the caption
title of a DivX disc is supported.
• Unsupported caption content will be
displayed using asterisks (*).
DivX can be divided into Video and Audio.
S
upported CODEC formats
Supported file format s
Supported audio formats
Supported caption formats
DivX3, DivX4, DivX5 (GMC 1WP)
*.avi, *.mpeg
AC3, MP3, WMA
* .SMI, * .SRT, * .SUB

How to make an update disc

Write the downloaded file onto a blank CD-R
disc, using the following settings.
1
You have to download a new file through
Download Center of Samsung Internet Site
(www.samsung.com).
2
Write the file to Disc using CD-RW of your
computer.
Note
- File System CD-ROM ISO Level
- Character set ISO 9660
- Finalized, single session
- Write speed low
Update procedure
1
Open the disc tray. Place the disc on the tray.
Close the tray. The Firmware upgrade screen
appears.
2
Press the ¦ or ‹ buttons to select Total,
then press the OK button.
- In the middle of the writing, the tray will open
automatically. After taking out the disc, please
wait for about 2 minutes.
Note
• The display can be changed depend on its
version and without any notice.
English - 35