Installation Methods - Kenwood KS-8200HT Bedienungsanleitung

Installation Methods

On the supplied speaker stand (Front speaker, Surround speaker)
The supplied speaker stands can be used to install either the front or surround speakers.
÷
The round encircled numerals in the following text refer to the items listed on the "Included parts list" page.
÷
The supplied speaker wires are color-coded according to the speakers to be connected. See the description in "Connections"
for details.
Note : Be sure to place the speaker stand in a flat, horizontal place.
Using the supplied speaker stands with the front speakers
1
Remove the two screws from the rear of each speaker.
2
Remove the cap and dressing sheet from the pole assembly 1.
3
Attach holder A 2 and holder B 3 to both sides of the pole assembly 1 as if sandwiching it, and insert the screws removed
from the speaker into the holes on the holders through them and the pole as shown in the figure. Make sure you attach the
holders correctly in the correct orientations.
4
Distribute the provided speaker wire through the hole on the holders and the hole on the bottom plate of the pole assembly 1
, and connect the speaker wire to the terminal on the speaker. Be sure to observe the polarity of the wire's conductors and
terminals when connecting. Next, insert the screws into the screw holes on the rear of the speaker and tighten them a little so
that they clamp the speaker loosely and that speaker can still be slid up and down.
5
After adjusting the speaker height by sliding it up or down, clamp the speaker by the screws completely. Then, insert the
dressing sheet into the groove on the pole from above.
6
Attach the cap to the top of the pole .
1 2
Screw
4
EN
3
Cap
Screw
1
Screw
3
Dressing sheet
Insert the speaker cord
here.
4
Top view
1
3 2
2