Installation Methods - Kenwood LS-5070ES Bedienungsanleitung

Installation Methods

On Floor or Shelf
Place the speakers on the floor or on a shelf or other horizontal
stable surface. Keep in mind that speakers are not fixed into
place, so be careful to avoid knocking them over.
On the Wall
This speaker system can be hung on the wall. With this installation method, the speaker should be installed upside down on the
wall. Proceed as follows.
1 Screw a single screw into the wall at the desired
location. Screw it only part way in, so that the screw
projects 9 to 11 mm (3/8 to 7/16 inches) outward from
the wall surface.
9 - 11 mm (3/8 to 7/16")
• Wall screw must be purchased separately.
3 Each speaker has a hole for attaching the provided wall-mount bracket on the rear panel. The bracket can be attached
to the speaker using the provided screw. When attaching the bracket, be sure to observe the front and back surfaces
and attach as shown below. After attaching, place the speaker upside down and fit the hole on the bracket around the
screw attached on the wall. Confirm that the speaker is held firmly and securely in place.
Bracket
Screw
(Accessory)
View of attached
bracket
On the speaker stand
The speaker can be installed on the SR-8000 stand optionally available from KENWOOD. Any
commercially available speaker mount or bracket can also be used (provided that the speaker
can be fixed using an M5 screw with a pitch of 60 mm and effective thread length of 7 to 10
mm). For details, read the instruction manual for the speaker mount or bracket.
Precautions
Please observe the following precautions when mounting the speaker onto the wall or speaker stand.
• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 2.2 kg [4.9 lb] ).
• Wall screw must be purchased separately.
• Be sure to use a screw that is appropriate for the wall or stand you are using, and that are long enough to provide
sufficient strength.
• If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this
type of installation, please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury
or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient
support strength.
4
EN
Cushion
2 Remove the grille and reattach it upside down.
Cushion
• Attach each couple of provided cushions to make two sets of two-cushion piles,
and attach them to the two positions shown on the rear of the speaker. These
piles will protect the speaker body from damage and prevent the vibrations of
the speaker body from being transmitted to the wall.
• Attach four cushions to the base of the
speaker, one at each corner. The cush-
ions prevent the speaker from sliding,
and dampen its vibrations.
Effective thread
length
M5 screw