Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation Methods
On Floor or Shelf
Place the speaker on the floor or on a shelf or other horizontal stable surface. Keep in mind that speaker is not fixed into place, so
be careful to avoid knocking it over.
7 Horizontal installation
• Attach four cushions to the base of the speaker, one at each corner. The cushions
prevent the speaker from sliding, and dampen its vibrations.
7 Slant installation
This speaker system can be installed at an upward or downward angle of about 10 degrees. This can be done by attaching the two
couples of feet with different lengths, provided with this speaker system, to the screw holes on the bottom.
Installing at an upward angle
Feet (Long)
Installing at a downward angle
Feet (Short)
On the Wall
This speaker include mount hole for wall mounting. You need to set two screws into the wall at the appropriate distance so that you
can hang the speaker from both mount holes. Proceed as follows.
1 Screw two screws into the walls 270 mm (10-5/8
inches) apart, making sure that screws are horizontally
level. Screw each screw only part way in, so that the
screw projects 9 to 11 mm (3/8 to 7/16 inches) out-
ward from the wall surface.
• Wall screws must be purchased separately.
2 Hang the speaker by fitting the two mount holes (at
the rear of the speaker) over the extending part of the
screw. Confirm that the speaker is held firmly and se-
curely in place.
• Attach each couple of provided cushions to make two
sets of two-cushion piles, and attach them to the two
positions shown on the rear of the speaker. These piles
will protect the speaker body from damage and pre-
vent the vibrations of the speaker body from being trans-
mitted to the wall.
Precautions
Please observe the following precautions when mounting speaker onto the wall.
•
Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 3.7 kg [8.2 lb] ).
•
Wall screws must be purchased separately.
•
Be sure to use screws that are appropriate for the wall you are using, and that are long enough to provide sufficient
strength.
•
If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this
type of installation, please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury
or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient
support strength.
Feet (Short)
Feet (Long)
270 mm
(10-5/8")
Mount hole
Cushion
Foot
9 - 11 mm
(3/8 to 7/16")
Cushion
3
EN
Werbung
Inhaltsverzeichnis
