Kenwood KS-8200HT Bedienungsanleitung Seite 5

5
Using the supplied speaker stands with the surround speakers
The method of mounting the surround speakers on the stands is variable depending on the front speaker installation
method.
When installing the front speakers on the desktop or shelf, remove the plates (small) from the speaker stands as described in the
following procedure before mounting the surround speakers on the stands. The removed plates (small) should be attached to the
front speakers (for the attaching method, see the description in "On the Desktop or Shelf" on page 6).
When installing the front speakers on the wall, it is not necessary to remove the plates (small) from the speaker stands. Simply
mount the surround speakers on the stands by following steps 2 to 6 in the procedure in "Using the supplied speaker stands
with the front speakers" on page 4. In doing this, however, the screws used in step 3 of this procedure should be supplied
screws. Do not pass the speaker wire through the hole on the holder but distribute it above the holder as shown below.
÷
The round encircled numerals in the following text refer to the items listed on the "Included parts list" page.
1
Disassemble the pole assembly into the bottom plate and pole by removing the retaining screws.
2
Disassemble the bottom plate into the plate (small) and plate (large) by removing the retaining screws.
3
Using the screws removed in step
4
Mount the speaker on each stand by following steps
the front speakers" on page 4. The screws used in step
speaker wire through the hole on the holder but distribute it above the holder as shown below.
1
Bottom plate
Screw
1
, attach only the plate (large) to the pole.
2 6
to
3
2
Screw
Plate (small)
Plate (large)
6
in the procedure in "Using the supplied speaker stands with
of this procedure should be supplied screws. Do not pass the
3
Screw
Installation Methods
How to distribute the speaker
wire
Insert the speaker
wire here.
Plate (large)
5
EN