Installation Methods - Kenwood KS-3200EX Bedienungsanleitung

Installation Methods

On the Desktop or Shelf
Place the speaker on the desktop, shelf or a similar level surface.
On the Wall
The speaker include mount holes for wall mounting.
1. Screw a single screw into the wall at the desired loca-
tion. Screw it only part way in, so that the screw
projects 8 to 10 mm (5/16 to 3/8 inches) outward from
the wall surface.
2. Hang the speaker by fitting the top mount hole (at the
upper rear of the speaker) over the extending part of
the screw. Confirm that the speaker is held firmly and
securely in place.
Precautions
Please observe the following precautions when mounting speaker onto the wall.
• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 0.6 kg [1.3 lb]).
• Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall you are using, and that
are long enough to provide sufficient strength.
• If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of
installation, please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury
or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient
support strength.
On the speaker stand
The speaker can be installed on the SR-8000 stand optionally available from KENWOOD.
Attaching the cushions
Attach cushions to the base of the speaker as shown be-
low. The cushions prevent the speaker from sliding, and
dampen its vibrations.
4
EN
8 - 10 mm
(5/16 - 3/8")