Microscope Assembling; B-510Bf / Ergo / Ph / Asb - Optika Italy B-510 Series Bedienungsanleitung

7.7

Microscope assembling

7.7.1 B-510BF / ERGO / PH / ASB

1. Insert the optical head above the stand and
tighten the screw. (Fig. 1)
• Hold the head with one hand during the
locking in order to avoid that the head falls.
2. Insert both eyepieces into the tubes of the optical
head. (Fig. 2)
3. Condenser is pre-installed in the factory. To
remove the condenser use an Allen wrench
1,5mm diam and operate on the locking screw
placed on the right side of the condenser holder.
4. Screw each objective into the thread of
the nosepiece,
magnification. (Fig. 3)
5. Insert the power supply jack in the connector
placed at the rear side of the microscope. (Fig. 4)
clockwise with increasing
Page 19
Fig. 1
Fig. 2
Fig. 3
Fig. 4