B Elt Grinding Attachment; C Ontact Arm; G Rinding Belts - SUHNER ABRASIVE LBC 16-TOP Originalbetriebsanleitung

3. h
andlIng
3.1 B
elt grinding AttAchment
Attach the belt grinding attachment to the drive at the po-
sition you want, and tighten the screw.
3.2 c
ontAct Arm
Loosen the knurled nut. Replace the contact arm, and
retighten the knurled nut.
3.3 g
rinding Belts
Use grinding belts only whose max permitted
speed is equal to or higher than the machine's idle
belt speed!
Install clean grinding belts only.
3.3.1 c
/o
peratIon
To change the grinding belt, first disengage the contact
arm and change the grinding belt.
Loosen setscrew (large). Optimize belt run with knurled
screw (small) and secure with setscrew. Dismantling the
belt grinding attachment according to Sec. 3.1
Optimize the grinding belt tension with hexagon spanner
and mount the belt grinding attachment again. Let the
tool run without load for at least thirty seconds.
/
hAnging fitting the grinding Belt
19