Interlogix ATSx500A serie Installationshinweise Seite 3

6 Install
>Cancel<
Change PIN
Installer
New PIN
>_
Verify
>_
Change PIN
Supervisor
New PIN
>_
Verify
>_
The panel restarts.
Auto configuration
Auto Config?
>Yes<
Rkp 1-16 BUS1
R-?-------------
Exp 1-15 BUS1
-?-------------
Aud 1-16 BUS1
---?------------
Added
R:1 D:0 Z:8
A:0
Enabling service in
UTC F&S
THU 05 Mar 12:21
1>Zone options
2 Isolate
8>Service in
Enable?
Press Cancel, Cancel to log off.
Programming menu entry
UTC F&S
THU 05 Mar 12:21
Inh reports
>No<
Inh tampers
Unset areas
1>Service menu
2 Device menu
The installer menu is displayed.
P/N 466-2523 (ML) • REV D • ISS 16JUN17
Choose OK
Press Enter to continue
Enter the new installer PIN and press
Enter
Next, enter the PIN again to verify it.
Press Enter to continue
Enter the new supervisor PIN and
press Enter
Next, enter the PIN again to verify it.
Press Enter to continue.
Wait until the panel configures all bus
devices and zones.
Press Enter to continue.
Enter the supervisor PIN and press
Menu
Go to menu 8.8 Service in
Enable Installer in time
Enter the installer PIN and press Menu
Press Enter to continue
Changing encryption key
Caution: It is highly recommended to change the default
encryption key.
Go to 9.4.3 Encryption key 1 and 9.4.4 Encryption key 2.
3 Encrypt.key 1
>000000000000<
4 Encrypt.key 2
>000000000000<
Configuring zones
Go to 4.1 Zone menu.
4>Zones&Areas
1>Zone menu
0>Add zone
1 Zone 1
For each zone used in the system, enter zone name in 4.1.n.1
Zone name.
01 Zone name
>1 Zone 1 <
Next, set its zone type in 4.1.n.2 Zone type.
02 Zone type
>Entry/Exit 1<
Adding users
Go to menu 3.1 Users.
0>Add user
1 Installer
Add mode
>Manual<
INFO
User added
01>User name
User 3
01 User name
>User 3 <
Configure other options of the user:
•
3.1.n.2 PIN
•
3.1.n.3 User card
•
3.1.n.6 User groups, etc.
Repeat for other users.
When leaving the user configuration, confirm locking the user
data.
Lock user data?
>Cancel<
Configuring areas
Go to 4.2 Areas menu.
Provide encryption key 1.
Provide encryption key 2.
Press Enter.
Press Enter.
Select a zone.
Press Enter to add a user.
Press Enter.
Press Enter.
Enter a new user name.
Choose OK and confirm.
3 / 42