Troubleshooting; How To Resolve Possible Problems - VLX 416S Bedienungsanleitung

How to resolve possible problems

[B]= battery machines
[C]= cable machines
PROBLEM
The machine does not
work
The brush doesn't rotate
The brush motor has trou-
ble in starting (cable mod-
els only)
The machine does not
clean evenly
No detergent is delivered
stop
The suction motor does
not start

TROUBLESHOOTING

CAUSE
[B]= battery connector disconnected
[B] [C]= fuse blown
[C]= the machine is not plugged into the mains
socket
you have not pressed the brush lever
[B] [C] the brush motor thermal cutout has
the power supply or motor thermal cutout con-
nectors are disconnected
[C]= fuse blown
the reduction unit is faulty
the motor is faulty
you are working with a dry brush on a very
you are working with power cable extensions
with an inadequate section, or the voltage is
considerably lower than the rated value for
the scrubber drier as shown on the rating plate
(15% less)
the motor is faulty
the brush or disk is worn
detergent tank empty
the hose delivering the detergent to the brush is
blocked
the tap is dirty or faulty
the solenoid valve is faulty
the solenoid valve is faulty
there is no power to the suction motor or the
motor is faulty
REMEDY
[B]= connect the batteries to the machine
[B]= charge the batteries
[B] [C]= replace the fuse
[C]= plug into the mains socket
press the brush button
surface
press the brush lever
[B] [C] release the brush lever, press the brush
for at least 45'
reconnect the power supply or motor thermal cut-
out connectors
[C]= replace the fuse
[B]= charge the batteries
have the reduction unit replaced
have the motor replaced
open the detergent tap
avoid the use of inappropriate extensions. In-
crease the section of the electric wires and locate
sockets with a higher voltage
have the motor replaced
replace
press the detergent button
turn the motor on by operating the brush lever
unblock and open the circuit
have the tap cleaned or replaced
replace the solenoid valve
replace the solenoid valve
• press the suction button.
check that the motor power connector is correctly
nected, have the motor replaced
GB
-
25