SUHNER LSC 20 Originalbetriebsanleitung Seite 5

Before installing extension hoses, blow them
clean and minimize , if at all necessary
coupling and keep them clean.
• Conserve:
Put some drops of oil in the air inlet and briefly
blow through.
Safety Instructions:
• Do not exceed max. operating speed of tool
and clamping element.
• Observe accurate mounting of insert tools.
• Observe mounting instructions for Mounted
Stones!
• Run tool for a couple of seconds under no
load, replace vibrating insert tools at once,
protect mounted points from knocks and
grease.
• Secure work, use clamp or vise to hold work.
• The grinder operator shall wear safety
goggles or face shield at all times when the
grinder is in operation.
• If noise level exceeds 85 dB(A) at the work
station, operator must use ear protection (plugs
and/or ear mufflers).
For additional safety instructions
refer to enclosed brochure DL 39 220 01
Operation conditions and instructions
Safety lever throttle action
Lever action:1 Tilt safety pin towards arrow
direction and 2 press down lever.
Grinding/Deburring/Cleaning
• Observe even material removal, avoid
chattering.
• Do not treat any material containing asbestos.
Change of tools/abrasives
• Disconnect air supply before changing tools/
abrasives
• Hold Spindle 3 with wrench 4, mount or
dismount clamping nut 5 using wrench 6.
• Check concentricity, use only vibration free
tools and always observe M.O.S. (Max.
operating speed). Observe mounting
instructions for Mounted Stones!
Maintenance
• Store tool in a clean, dry place.
Check the idling speed from time to time.
• Even if the tool still gives satisfactory service,
have it checked by a trained mechanic after
300 to 400 operation hours, or at least once a
year. Disassembly motor, clean and replace if
necessary the four vanes.
•Replace grease with Molykote BR 2 plus in
gear head, 1 don't rinse tool.
• Warranty claims can only be considered, if
tool is returned complete.
Accessories:
All accessories can be found in the SUHNER
Abrasive Power Tool catalog.
Subject to change.