Tecsis P2600 Betriebsanleitung Seite 21

7. Installation, commissioning, operation
If the line to the gauge is not rigid enough for a vibration-free installation, the
gauge should be mounted by means of appropriate fastening elements for wall
mounting, or, if necessary, with a capillary.
Wall mounting (see drawing)
Installation / fastening by means of mounting brackets
Drag pointer
Electrical connection (for instruments with electrical accessories)
Electrical connection of the pressure gauge is by means of terminal box and
cable. Precise wiring schemes can be seen in the following connection diagram.
In addition both the pin assignment and the required power supply are stated on
the product label of the reed case.
Electrical connection diagram
Reed contact model 6.3 and 6.3.3
(change-over contact)
Operating instructions
with reed contact
Plug
6.3. 3
2nd contact
6. 3
1nd contact
Terminal box
without reed contact
Slotted screw M4 x 10
Reed case
The instruments do not
provide for incorporated
overcurrent protectors. If
overcurrent protectors are
requested, these have to
be provided for externally.
GB
Hexagon bolt
M8 x 50 (M8 x 100)
21