Options And Accessories - Tecsis P2600 Betriebsanleitung

5. Options and accessories

In processes with loating particles model P2600 with Reed contact should be
used.
Scope of delivery
Cross-check the scope of delivery with the delivery note.
5. Options and accessories
5.1 Mounting lange
May be retroitted on site as required.
Alignment of the front bezel (A) by means of the stamped cams to the grooves
found on the case circumference. Push front bezel on the case until it snaps into
position.
5.2 Minimum or maximum drag pointer (see illustrations)
The drag pointer (B) serves to monitor and control the miniumum or maximum
occurring differential pressure.
5.3 Reed contact model 6.3 and 6.3.3 (see illustrations)
May be retroitted and adjusted on site as required.
Fastening is by means of two screws (D) integrated in the reed case (C) on the
display case with the pertinent female thread.
A
Operating instructions
C
B
D
C
B
GB
D
19