Storage, Transport, Disposal; Operating Anomalies And Troubleshooting - Tractel dynafor LLX1 Serie Gebrauchs- Und Wartungsanleitung

10. STORAGE, TRANSPORT, DISPOSAL

Storage: Place the appliance in its original packaging, with the sensor batteries removed. Keep in a
warm, dry place.
Transport: Transport the appliance in its original packaging.
IMPORTANT: Avoid subjecting the dynafor™ LLX1 to shocks.
Disposal: Any disposal of the appliance must be carried out in compliance with the regulations in force
in the country of use. For countries subject to European regulations, the dynamometers and
remote controls (display units) do not come under the terms of the "DEEE" and "RoHS"
directives.

11. OPERATING ANOMALIES AND TROUBLESHOOTING

GB
Display
No initial reset
The sensor does not
switch on
The display unit does not
switch on
No display evolution or
display inconsistent.
Linearity or precision
problem.
Possible causes
Tare Function enabled.
Permanent deformation of
the sensor following a
handling error; excessive
overload or compression.
Dead batteries.
Electronic fault.
Dead power pack.
Electronic fault.
Sensor or sensor electronics
malfunction.
Sensor or sensor electronics
malfunction.
22
Solutions
Disable the Tare function and
display the "GROS" stress
value.
The appliance should be
checked by the
manufacturer before you
continue using.
Change batteries.
Contact the after-sales service.
Charge power pack.
Contact the after-sales service.
Reset: Switch off the sensor
and display unit and then
switch on the sensor followed
by the display unit.
In the event of persistent
malfunction, contact the after
sales service.
Contact the after-sales service.