Installation, Utilization And Uninstallation; Conditions Prior To Set-Up And Use; Installation, Utilization, Uninstallation; Utilization Prohibitions - Tractel dynafor LLX1 Serie Gebrauchs- Und Wartungsanleitung

3. INSTALLATION, UTILIZATION AND UNINSTALLATION

3.1 Conditions prior to set-up and use

- Altitude: Up to 2000 m
- Relative humidity: Max 80 %
- Degree of pollution assigned: 2
Before setting up and using the dynamometer you must:
a) make sure that there is no stress value shown when the appliance is not subject to traction.
Should this occur, refer to Chapter 11 Operating Anomalies and Troubleshooting.
b) make sure that the sensor batteries and display unit power pack are adequately charged.
c) make sure that you have the correct radio link between the sensor and the display unit.
d) use the "ID" icon to check that the sensor serial number shown on the sensor plate is
the same as the sensor serial number shown by the display unit (see section 6.2.2 and
section 6.2.3).

3.2 Installation, Utilization, Uninstallation

GB
Refer to the documentation for the LLX1 sensors.

4. UTILIZATION PROHIBITIONS

IT IS PROHIBITED:
• To use dynafor™ in a line for lifting people without having carried out a prior
specific risk analysis.
• To modify the appliance housing by machining, drilling or any other process.
• To use dynafor™ beyond their maximum capacity.
• To put the Dynafor in a arc weld electrical circuit.
• To disassemble or uncover the sensor or display unit.
• To use the appliance for operations other than those described in this manual.
10