G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Declaration Of Conformity - SUHNER ABRASIVE ROTOfix Originalbetriebsanleitung

1. N
1.1 g
enerAl notes on sAfety
This technical document is applicable for the machine
ROTOfix. The machine may only be handled by person-
nel who are qualified.
Hold power tools by insulated gripping surfaces when
performing an operation where the cutting tool may con-
tact hidden wiring or its own cord. Contact with a «live»
wire will make exposed metal parts of the tool «live» and
shock the operator.
WARNING Read all safety warnings and all in-
structions. Failure to follow the warnings and in-
structions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
1.2 u
se of the mAchine for purposes for
which it is intended
The machine with adjustable speed drive is intended ex-
clusively for use as a hand-held tool for grinding or polish-
ing without the use of water. Make sure that only SUHNER
products are used as flexible shafts, hand tools and abra-
sives. A grounding connection or grounding with a fault
current switch is required. Flexible shafts with connection
thread M10 (type DIN 10) or G28.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2014/30/
EU, 2006/42/EC, 2011/65/EU. Applied standards: EN ISO
12100, EN 60745, EN 55014-1, EN 55014-2, EN 61000-3-
2, EN 61000-3-3. Document Agent: M. Voyame. D-Bad
Säckingen, 02/2019.
M. Voyame/Division manager
2. c
2.1 p
rior to tAKing the mAchine into serVice
Before connecting tool to a power
source, be sure the voltage sup-
plied is the same as specified on
the name plate of the tool.
24
s
otes oN afety
ommiSSioning
2.2 t
AKing the mAchine into serVice
2.2.1 f
lexiBle shAft
Block threaded connection with locking pin. Use lock-
ing pin to screw threaded coupling onto the shaft. Insert
locking knob and hose coupling into the connection bore.
Make sure that the locking knob snaps in.
2.2.2 A /
ttAching detAching the hAnd tool
Press locking knob. Slide hand tool over the hose cou-
pling. Make sure that the locking knob snaps in. For more
information please refer to the user's manual of the hand
tool.
2.2.3 A /
ttAching detAching the ABrAsiVe
For detailed information please refer to the user's manual
for the hand tool used. The abrasive must be fastened
snug against installed tools.
Let the abrasive run briefly at idling speed without
load. In the event of strong vibrations or other de-
ficiencies shut down the machine immediately
and rectify deficiencies or fit a new abrasive.
2.2.4 s
Afety guArd
If a safety guard is supplied with the hand t