Ayce 2717 Gebrauchsanweisung Seite 45

!
Check that the application tools are correctly attached. Incorrect or
insecurely fastened application tools can come loose during operation
and cause a hazard.
WARNING
1. Disconnect the tool from the power source.
2. Turn the quick change lever anticlockwise until you can loosen the flange bolt.
Press and turn the flange bolt clockwise to 90° position. Remove the flange
bolt.
3. Ensure that the attachment plate and the drive shaft are clean.
4. Align the grooves on the suitable accessory with the ribs on the adapter. Put
the accessory onto the attachment plate.
5. With your gloved hand holding the accessory, insert the flange bolt, depress
and turn it anticlockwise at 90°
6. Turn the quick change lever back to lock the drive shaft.
NOTE: Attach the application tool at the desired orientation for the task at hand. The
shaft is configured so that the application tool can be attached every 30°around the
shaft, from 0°to 330° (Fig. 2)
Fig. 2
During use we do not recommend to attach the application tool
!
facing backwards, as operation in this position may cause serious
injury. (Fig. 3)
WARNING
180731_ayce_2717_IM
Fig.
3
b. Mounting/changing the sandpaper (Fig. 4)
Fig.
4
! During sanding, always connect dust extraction with extra sanding
accessories.
WARNING
88 89 |
1. Follow the directions for attaching
the application tool to attach the
sanding plate to the multi tool.
2. Align the sandpaper with the sanding
plate and use your hand to press it
firmly on the sanding plate.
3. Press the sandpaper firmly against
a smooth surface for a short period,
and then switch on the tool. The burr
will form a non-slip bond with the
outer edge of the sandpaper felt.
This will avoid premature wear.
If one point has become worn, pull off the
sandpaper, turn it 120° and place it on
again.
180731_ayce_2717_IM
GB
GB