Ec Declaration Of Conformity; General Power Tool Safety Warnings - DeWalt D25413 Bersetzt Von Den Originalanweisungen

ENGLISH
The vibration emission level given in this information
sheet has been measured in accordance with a
standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
WARNING: The declared vibration
emission level represents the main
applications of the tool. However if the
tool is used for different applications,
with different accessories or poorly
maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working
period.
An estimation of the level of exposure to
vibration should also take into account
the times when the tool is switched off
or when it is running but not actually
doing the job. This may significantly
reduce the exposure level over the total
working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and
the accessories, keep the hands warm,
organisation of work patterns.
Fuses:
Europe 230 V tools
U.K. & Ireland 230 V tools
Defi nitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and
pay attention to these symbols.
DANGER: Indicates an imminently
hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING: Indicates a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
NOTICE: Indicates a practice not
related to personal injury which, if
not avoided, may result in property
damage.
Denotes risk of electric shock.
Denotes risk of fire.
28
EC-Declaration of Conformity
MACHINERY DIRECTIVE
D25413, D25414, D25415, D25430
D WALT declares that these products described
E
under Technical Data are in compliance with:
2006/42/EC, EN 60745-1, EN 60745-2-6.
These products also comply with Directive
2004/108/EC and 2011/65/EU. For more
information, please contact D
address or refer to the back of the manual.
D25430
D WALT declares that these products described
E
under Technical Data are in compliance with:
2000/14/EC Electrical concrete breaker (hand held)
m</= 15kg, Annex VIII; TÜV Rheinland Product
Safety GmbH (0197), D-51105 Köln, Germany,
Notified Body ID No.: 0197
Level of acoustic power according to 2000/14/EC
(Article 12, Annex III, No. 10; m</= 15 kg)
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
10 Amperes, mains
D WALT.
E
13 Amperes, in plugs
Horst Grossmann
Vice President Engineering and Product
Development
D WALT, Richard-Klinger-Straße 11,
E
D-65510, Idstein, Germany
29.11.2013

General Power Tool Safety Warnings

WALT at the following
E
L (measured sound power level)
WA
L (guaranteed sound power level) dB 105
WA
WARNING: To reduce the risk of injury,
read the instruction manual.
WARNING! Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions may result
in electric shock, fire and/or serious
injury.
dB 99