Keys; Input And Output Selections; Active Monitor Selection; Input Selection - Videotec KEYPLUS Bedienungsanweisung

Keys

COM FAULT
ALARM
1
- / - -
6
The SW164OSM keyboard allows to control the SW164OSM video matrix.
0
Numerical Keys
s
Shift : it's used to select an input from 10 to 16. After pressing Shift, choose the second digit of the desired number:
s3
i.e.
m
Monitor : to choose the monitor to be switched on
B D
Up / Down /
P
Prog : to enter in programming mode (a password can be required).
C
Clear : with the SW164OSM it carries out a screen refresh. It is not used with SW164 Standard.

Input and output selections

Active monitor selection

m
Monitor prepares the keying in of the monitor number.
Each keyboard can control up to 4 monitors, but only one can be used at a time as active monitor for switching
operations.
Selectable monitors can be configured during the keyboard setup.
Pressing this key, the symbol ? will appear indicating the necessity to key in the monitor number (from 1 to 4).
Selecting a disabled monitor an acoustic message will follow.
Example: select monitor 2 as active monitor
Current input
MONITOR 1
INPUT 3

Input selection

0 9
Keys / : They are used to select directly a video input from 1 to 9.
To select video input from 10 to 16, press
number 13. Input 10 can be selected even pressing the key
B D
Up / Down /
Automatic/ Manual
M/A
PROG
2 3 4 5
CLEAR
ENTER
7 8 9 0
9
/ : used to select inputs
to select input number 13.
: selection of next or previus video inputs on active monitor
Keys
m 2
s
: To select the previous or next input of the one shown on the monitor.
M
selection of automatic switching cycle, matrix-defined for each user.
New input
MONITOR 2
INPUT -
and the second digit of the number: for example,
0
.
Page 16
s 3
to select input
KEYPLUS9702