Cleaning The External Surface Of The Scanner; Disposal - imacon Flextight Precision II Anwenderhandbuch

4. Locate the broken lamp. Hold each end of the lamp between your
thumb and index Þnger. Rotate the lamp until it comes free and
pull it away from the scanner. Note that the lamp sockets allow the
tube to be rotated all the way around, but they click into position at
each quarter turn. The lamp is locked in place in all but one of these
four positions, so you may need to try up to three positions before
the lamp comes free.
5. Install a new lamp following the reverse of the procedure you used
to remove it. Make sure the sleeve is aligned correctly with the
scanner as shown in Figure 8. Rotate the lamp and/or adjust the
sleeve as necessary.
6. Replace the side panels.

Cleaning the External Surface of the Scanner

If the external surface of the scanner becomes dirty, then clean it with a
damp cloth. Be careful not to get any moisture inside the scanner or on
any of the connectors. Do not use alcohol or other solvents.

Disposal

If you need to dispose of the scanner, it must be delivered to the local
waste plant.
Imacon Flextight Precision II UserÕs Guide
Hardware ReferenceÑFlextight Precision II
Cleaning the External Surface of the Scanner
27