imacon Flextight Precision II Anwenderhandbuch Seite 15

7. Connect the round connector from your power supply to the round
socket on the back of the scanner.
8. IMPORTANT: Make sure that the wall socket you are planning to
use meets the electrical requirements outlined above.
Plug the Flextight Precision II power supply into a wall socket.
Note that the power supply may emit a low buzzing sound when
plugged in. This is normal and will not damage the power supply
or scanner.
9. Turn the scanner around so that the side with the red button is fac-
ing you as you sit at your computer.
10. Press the red power button on the front of the scanner to turn it on.
The green light starts ßashing. This means that no Þrmware has
been downloaded yet. It will be downloaded automatically later
when you Þrst run the ColorFlex software.
11. Your system is assembled. Turn on your computer and install the
ColorFlex image scanning software.
Imacon Flextight Precision II UserÕs Guide
Hardware ReferenceÑFlextight Precision II
Setting up the Scanner
13