imacon Flextight Precision II Anwenderhandbuch Seite 17

edges to avoid Þngerprints. Curl the plastic layer back and slip
the front edge into FlextightÕs foil holder.
7. Lay the top layer of the holder down ßat over the original.
¥ For transparency holders, the top layer is magnetic, which will
hold the original fast.
¥ For the reßective holder, note the four metal pegs (the top two
are shown as A and C below); make sure that the clear plastic
sheet is pressed all the way down over all four pegs. Note also
the two curved tabs at the top of the holder (B in the Þgure
below); the clear sheet must slip under each of these tabs, as
shown.
Figure 5: Reßective holder, top
8. Go to your computer and run the scanning software. Follow the
directions given in the ColorFlex software manual to take a pre-
view, make settings, and take the Þnal scan.
Imacon Flextight Precision II UserÕs Guide
Hardware ReferenceÑFlextight Precision II
Operating Instructions
15
A
B
C