Technical Specifications - Emos P3534 Bedienungsanleitung

GB | Rechargeable LED CREE Headlight with IR Sensor
Characteristics
The headlight's light source is a powerful CREE LED chip. The headlight has a built-in Li-Pol accumulator which can be recharged through
a cable with micro-USB connector. The low weight and small size of the lamp make it ideal for outdoor activities as well as other occasions
where you need a powerful yet compact light source.

Technical Specifications

Light source: 1× white CREE LED 5 W
Power supply: Li-Pol 1 200 mAh
Modes: 100 %, 50 %, 20 %, off + SOS flashing
Range: 75 m
Light duration: 3 hours
Max. luminous flux: 230 lm
Dimensions: 61 × 31 × 33 mm
Weight: 60 g
Turning the Headlight on Manually
1. Pressing button 1 on the top turns on the headlight – the CREE LED will glow at 100 % power.
2. Press button 1 on the top of the headlight again – the CREE LED will glow at 50 % power.
3. Press button 1 on the top of the headlight again – the CREE LED will glow at 20 % power.
4. Pressing button 1 on the top again turns off the headlight.
Manually Turning on SOS Signal
1. Hold down button 1 on the top of the headlight for 2 s – the CREE LED will flash SOS signal.
2. Pressing button 1 on the top again turns off the headlight.
Turning on the Headlight Contactlessly via IR Sensor
1. Pressing button 2 on the top of the headlight turns on the IR sensor.
2. The lamp will turn on once the IR sensor is activated.
3. Moving your hand in front of the spotlight will turn off the lamp.
4. Pressing button 2 on the top of the headlight turns off the IR sensor.
5. The IR sensor can also be activated while manual mode is on by pressing button 2. The IR sensor does not work with black rubber materials.
Charging the Accumulator
The lamp's accumulator must be charged before first use.
Charge the lamp in dry indoor areas at a temperature of +5 °C to +45 °C.
If the lamp is not used for an extended period of time, it is necessary to recharge the accumulator before further use. The accumulator
self-discharges and must be recharged at least once every 3 months to prevent its voltage from dropping and the accumulator potentially
being rendered unusable.
Charging procedure:
1. Turn the rubber blank on the lamp body until the power connector is visible and connect the power cable.
2. The lamp body will glow red while charging. Once the lamp (accumulator) is fully charged, it will glow green.
3. After fully charging, remove the power cable and turn the rubber blank on the lamp so that water, humidity or dust cannot enter
into the head lamp.
Warning
• When new, the lamp must first be charged before use.
Description of Control Elements and Parts
1 – Manual on/off button
2 – Button for turning IR sensor on/off
3 – CREE LED 5 W
4 – IR sensor
5 – Micro USB connector cover
2