Hitachi DW25EA SN Bedienungsanleitung Seite 10

DW25EC (SKN)
To tighten the chuck more securely, set a
19mm spanner (1) between gear case
and drill chuck to lock drive shaft. Turn on
lock lever (2) then hit the mounted chuck
handle with a hammer to screw in
(clockwise) the chuck.
(DW25EB(SK)/DW25EB(SKN)/DW25EC
(SKN)/DW25ED(KP)/DW25ED(KPN)/DW
25EF (SK)/DW25EF (SKN)) (Fig. 2-6)
To loosen the chuck, set the spanner on
the other side and hit the chuck handle
from this side to screw out (counter-
clockwise), the chuck with the lock lever
on.(DW25EB(SK)/DW25EB(SKN)/DW25
EC (SKN)/DW25ED (KP)/DW25ED
(KPN)/DW25EF (SK)/DW25EF (SKN))
(Fig. 2-6B)
Fig. 2-6
Fig. 2-7B
Fig. 2-8B
Note! In case of DW25EB (SR)/DW25EB
(SRN)/DW25EF (SR)/DW25EF (SRN),
use chuck mount wrench (3) in place of
chuck handle and tighten or untighten
manually instead of hitting. Do not hit the
chuck mount wrench.
(Fig. 2-7, 7B)
To install or loosen the keyless chuck, set
a 19mm spanner (1) between gear case
and chuck to lock drive shaft. Install the
locking bar (2) in the tool bag into the
chuck, and then tighten(clockwise) the bar
(2) with the enclosed box spanner or
loosen (counter-clockwise) . (Fig.2-7C)
Fig. 2-6B
Fig. 2-7C
Fig. 2-8C
Stopping (Fig. 2-8, 8B, 8C)
Decrease engine speed, and push
ignition switch to stop position.
G
B
Fig. 2-7
Fig. 2-8
GB-9