Rear Display Unit Installation
Be sure to disconnect the power cable of the main block (POS Workstation) and
confirm the power is "OFF" before the operation below.
Rear display unit (JS-960RD-010) contents
Rear display x 1
(1) Follow steps (1) and (2) of "Storage Unit Replacement (Stand Unit)" to remove the rear
cover.
(2) While pushing in the cable cover release button, slide the cable cover with both hands
to remove it.
(3) Insert the shaft of the rear display hinge part into the hole in the hinge plate attached to
the main block.
(4) Push the rear display latch hook in until it clicks to lock it into place.
(2)
(4)-2
30
(3)
(4)-1