Display Unit Replacement - Panasonic JS-960WS Serie Bedienungsanleitung

Display Unit Replacement

Be sure to disconnect the power cable of the main block (POS Workstation) and
confirm the power is "OFF" before the operation below.
(1) Raise the display unit to its highest position, and then, while pressing the cable cover
release buttons on both sides of the cable cover, lift up the cable cover with both
hands.
(2) Open the screw covers (2 locations) of the main unit.
(3) Loosen the 2 thumbscrews securing the display unit.
p Loosen the thumbscrews until they are extended by their springs.
p If you continue to loosen the thumbscrews further after they are extended, they
could become detached. Make sure not to detach them.
(4) Hold the both sides of the display unit and pull out the unit slowly.
(5) Hold the new display unit with both hands and insert the connector section of the
display unit into the connector inlet guide of the main unit slowly to connect the
connector.
p When the connector section is connected, do not press the LCD surface of the
display unit.
(Failure to observe this may result in damage to functions of the LCD or touch
panel.)
(1)-1
Cable
cover
release
button
(3)
24
(1)-2
(4)
(2)
(5)