Cognex In-Sight 7600 Serie Installationsanleitung Seite 9

Install the C-Mount Lens and Lens Cover
Accessory
Complete the following steps to install a standard or extended C-Mount lens with the
standard lens cover (COV-7000-CMNT) or extended lens cover (COV-7000-
CMNT-EX) accessories.
1. Remove the rubber faceplate covering the image sensor window, if
present.
2. Remove the protective film covering the threaded lens opening, if present.
3. Place the lens cover adapter on the faceplate of the vision system. Insert the
four adapter screws and tighten; the maximum torque is 0.26 Nm (37.5 in-
oz).
4. Thread the lens into the vision system.
5. Attach the standard lens cover (COV-7000-CMNT) or extended lens cover
(COV-7000-CMNT-EX) to the vision system. Rotate lens cover clockwise
approximately seven degrees to lock it.
8