Cognex In-Sight 7600 Serie Installationsanleitung Seite 10

Install the Mounting Bracket (ISB-7000-7K)
The accessory mounting bracket kit (ISB-7000-7K) includes the mounting bracket,
M3 screws (quantity 4) and a hex wrench for attaching the vision system to the
mounting bracket. The mounting bracket also has 1/4 - 20, M6 and flathead
mounting holes for mounting the vision system to a mounting surface.
CAUTION:
It is recommended the vision system be grounded, either by mounting
l
the vision system to a fixture that is electrically grounded or by
attaching a wire from the vision system's mounting fixture to frame
ground or Earth ground. If a ground wire is used, it should be
attached to one of the four mounting points on the back plate of the
vision system; not to the mounting points on the front of the vision
system.
When mounting the vision system to the mounting bracket, use the
l
M3 screws supplied with the mounting kit. If using the 1/4 - 20 or M6
screw holes on the mounting bracket to secure the vision system to a
mounting surface, the insertion depth of the screw should not exceed
7mm. Allowing the mounting screws to bottom in the mounting hole
can damage the vision system.
1. Align the mounting bracket with the mounting holes on the vision system.
2. Insert the M3 screws into the mounting holes and tighten using a 2.5mm hex
wrench; the maximum torque is 0.90 Nm (8 in-lb).
9