Acson international SL35C Montageanleitung Seite 7

Fig B
Please ensure that the following steps are taken:
• Check the gradient for drainage flow as recommended in Figure B.
• Provide clearance for easy servicing and optimal air flow as shown in Figure C.
• The indoor unit must be installed such that there is no short circuit of the cool discharge air with the warm return air.
• Do not install the indoor unit where there is direct sunlight shining on the unit. The location should be suitable for piping
and drainage installation. The unit must be a large distance away from the door.
Fig C
Min. 400.0mm (15.75")
Max. 250mm (9.84")
Min. 300.0mm (11.81")
Utensils, Furnitures Or Built-
In Architectural Features
Must Not Protrude More
Than 250.0mm
Ceiling Type
Floor Standing Type
1-5
Min. 10.0mm (0.39")
Min. 1.0m (39.37")