Replacing The Guide - EFA SB 322 E Betriebsanleitung

C
A
B
D
Fig. 5: Saw belt guide
- Running traces on the carbide metal
- Gap set to 0.6 mm in the factory
- Turn rods (b) if running traces occur
 Worn carbide metal plate (a)
(groove marks) can be turned (all 4
sides can be used). Turning the
plate early prevents cracks on the
back of the saw belt.
The carbide metal rods (b) cannot

be adjusted. They may be turned to
make best use of the entire
circumference at the top and bottom
ends. Replace worn rods. This is to
prevent cracking and to warrant
correct sawing results.
 Check that the saw belt guide can
move freely.
 Regularly check the fibre guide (d)
for wear and replace as necessary.

4.2.1 Replacing the guide

Replace the fibre guide
when its gap is wider than 2
mm.
The illustrations below help to explain how
the entire guide assembly provided to guide
the saw belt (lever, fixture and fibre guide)
can be disassembled for maintenance
purposes. In order to maintain a tidier
Schmid & Wezel
D-75433 Maulbronn
picture, disassembly is only shown for the
rail side. The assembly can also be
uninstalled with the rail mounted on the saw.
 Open the lids (A) and remove the
saw belt from the guide, see section
"Disassembling the saw belt".
Fig. 6: Replacing the guide
2
Fig. 7: Replacing the guide (2)
Push the lever down (1)
The guide will move up (2)
Page
39 of 58
(1)
1
Version 1
07.2012