Safety Instructions; General Safety Precaution; Behaviour At The Place Of Work; Connecting And - EFA SB 322 E Betriebsanleitung

2. Safety instructions

2.1 General safety precaution

Be sure to observe the following safety
precautions when working with the belt
saw.
 Changing the belt as well as
installation, maintenance and repair
work may only be carried out when the
machine is disconnected from the
mains!
 Select personal protection equipment
according to the regulations applicable
on the premises and to the accident
prevention regulations in force.
 Operation presupposes that the
operating personnel has sufficient
knowledge on the use of the unit.
 Expert training is provided by Schmid
& Wezel.
 Installation, maintenance and repair
work may only be carried out by
authorised and qualified personnel.
 The machine is equipped with a two-
hand safety circuit.

2.2 Behaviour at the place of work

 Keep your place of work tidy.
Untidiness can lead to accidents.
 Give consideration to environmental
influences. Ensure good lighting (min.
500 lux).
 Keep other people away from your
place of work. Work in a concentrated
and sensible manner. Do not use the
belt saw when you are unconcentrated
and/or tired.
 Do not wear loose clothing or jewellery
as these could become tangled up in
moving parts. Wear solid shoes when
working. Wear a hair net as a general
rule!
Schmid & Wezel
D-75433 Maulbronn
The two switches
have to be pressed
simultaneously
(within 0.3 seconds).
 Avoid abnormal body postures. Ensure
a safe working position and keep your
balance at all times.
 Keep the belt saw in a safe place.
Store the unit in a dry place when not
in use.
 Use only original EFA accessories.
Use of other accessories will void the
warranty. Use of other tools or
accessories may result in injury to
yourself.
Do not leave wrenches on the

machine. Check that all wrenches
have been removed before starting the
machine.

3. Connecting and

Starting Up

Place of work
The operator's place of work should have a
surface of at least 1.5 m². No other working
location should overlap into this area,
otherwise a risk of injury could ensue due to
movements of the splitting saw.
The illumination at the place of work must be
at least 500 lux.

3.1 Installations

Page
35 of 58
Switch off the
splitting saw before
connecting to the
mains power supply!
Important
information, e.g.
technical data
sheets, drawings and
parts lists can be
found in the annex.
Version 1
07.2012