De Dietrich DOP350 Bedienungsanleitung Seite 53

99625044_ML_A.qxd 24/07/03
f) After the oven has cooled down, use a damp cloth for removing the white ash.
The oven is now ready for use.
Note: The pyro-cleaning temperature cannot be altered. During the cleaning
cycle the lighting is switched off. If your oven is still not clean after pyro-clea-
ning you have delayed cleaning too long. Repeat the operation.
2)Program your pyro-clean to start when you want
Follow the instructions given in the section entitled "How to use the pyro-clean pro-
gram", then:
1) For "Pyro Control":
a) Press touch control
flashes and the
b) Set the time the program is due to start by pressing the+ or - touch controls.
Example: Begin the pyro-clean program at 5 am (05:00)
When the pyro-clean program is over press the START/STOP touch control.
NOTE : As the duration of the pyro-clean cycle is calculated during the cycle itself,
depending on the state of the oven, you can only adjust the time at which the cycle
starts.
2) For the 2 hour Pyro:
a) Press touch control
that this time can be modified.
b) Set the time the program is due to finish by pressing the +or - touch controls.
Example: End of pyro-clean program at 5:00.
When the pyro-clean program is over press the START/STOP touch control.
16:56 Page 53
, the starting time of the pyro-clean program
symbol also flashes to show that this time can be modified.
START
STOP
,the finishing time for the pyro-clean pro-gram
flashes and the
START
STOP
ECO
symbol also flashes to show
ECO
GB
53