PEAKnx wantec Monolith C IP Bedienungsanleitung Seite 22

EN Set up of an wantec doorstation with a PEAKnx touch panel
19. You can make further settings under „Service Settings". Select „Next Step".
20. Select the download for Windows and install the software on the Controlmini/-pro.
21.
Open the software and log in. Allow access to the device.
22.
The green handset indicates that the phone has successfully registered with your
Fritzbox.
23.
To ensure that the Bria Solo Free App starts automatically when the system is
rebooted, open the settings under Softphone->Preferences and check „Launch when
Windows starts".
24. To test the correctness of these settings, press the bell on your wantec door station.
After a few seconds, your PEAKnx touch panel should display an incoming call notifi-
cation.
22
www.peaknx.com