PEAKnx wantec Monolith C IP Bedienungsanleitung Seite 20

EN Set up of an wantec doorstation with a PEAKnx touch panel
your PC in your browser, making sure that the system running the browser is on the
same network as the PEAKnx touch panel. To do this, enter the following URL in your
browser:
■
http://x.x.x.x:31228
■
Where x.x.x.x must be replaced by the local IP address of your PEAKnx touch
panel. This can be found in the Fritzbox settings (fritz.box) under Home network
and the respective device.
■
From the menu on the left, select "Cameras".
3. Use the „+" symbol to add a new camera set.
4. Click the "+"-Symbol next to "Select Camera Stream" to create a new camera stream.
5.
For the "Stream Name", enter an appropriate name of your preference.
6.
Change the „Stream Type" to „JPEG".
7. Enter the link of the camera stream from your door station under „Low Resolution
URL" as well as under „High Resolution URL".
■
This link consists of the IP address of the door station (port= 80) and „/video.jpg",
for example: http://192.168.188.250:80/video.jpg
8.
Enter 500 ms for the refresh interval.
9.
Click "Save" to register the settings with your PEAKnx touch panel.
10. Within the PEAKnx touch panel, switch back to YOUVI Visu
11. In order to ensure that the visualization is automatically activated when the system is
rebooted, open the YOUVI Visu settings under Auto start and activate this feature.
12.
Now switch on the Edit Mode and switch to the Dashboard.
13.
Select the „Webcam" button to select a Camera created in YOUVI Configuration.
20
www.peaknx.com