Setting Up The Wantec Door Intercom - PEAKnx wantec Monolith C IP Bedienungsanleitung

phone number" and enter the phone number „** xxx" of the Controlmini in the
Fritzbox. In this example, that would be the „** 627".
13.
You will get an overview, which you can confirm with „Apply".

2. Setting up the wantec door intercom

14.
Connect the wantec device to a PoE-enabled switch on your network.
15.
To be able to set up the Monolith C IP, you must enter its IP address into your browser.
It is also specified in the instructions of the door station, e.g.: 192.168.1.250.
■
At fritz.box under Overview->Home network, the active clients/devices are dis-
played. Here you will also find the IP address of the door intercom. Enter it in the
browser to reach the configuration page of the door station.
■
Depending on the configuration of your network, at least the fourth digit
sequence of the IP address should match those of the instructions.
16. Enter the displayed IP address in the browser to configure the wantec door station.
17. The camera stream is displayed. Scroll down and click „Setup".
18.
The default user name is: „admin", the password is „1234".
EN Set up of an wantec doorstation with a PEAKnx touch panel
www.peaknx.com
17