Setting Up The Youvi Camera Module (With Bria Solo Free) - PEAKnx wantec Monolith C IP Bedienungsanleitung

■
In the „Recording" tab, select the first microphone.
■
In the following menu, you can set the microphone level in the „Levels" tab.
25. To use the door station with the Controlmini, check that the sound settings of the
Controlmini are set as shown in the picture. Therefore, proceed in the same way as for
the Controlpro.

3. Setting up the YOUVI camera module (with Bria Solo Free)

Notes on the camera stream
On the configuration page of the door station, under Extended settings->Video, you will find
various settings for entering the resolution and frame rate. Please keep in mind that high
frame rates and resolutions will additionally burden your network.
To make use of the wantec door station's camera, it needs to be added and set up within
YOUVI Configuration.
1. To add the camera module open YOUVI Dashboard on the panel and select Install
Camera Device. If you do not have a full license yet, you can purchase it in the PEAKnx
Shop.
2. Switch to YOUVI Dashboard -> Camera Device OR open the configuration page on
EN Set up of an wantec doorstation with a PEAKnx touch panel
www.peaknx.com
19