Introduction; Fritzbox Configuration; Setting Up The Controlmini/-Pro In The Fritzbox; Setting Up The Wantec Door Intercom In The Fritzbox - PEAKnx wantec Monolith C IP Bedienungsanleitung

EN Set up of an wantec doorstation with a PEAKnx touch panel

Introduction

The following instructions explain how to set up an wantec Monolith C IP door station with
your PEAKnx touch panel. The communication between the touch panel and the door sta-
tion is realized via SIP. Therefore, please make sure that both devices are part of the same
network and that YOUVI has Internet access.

1. Fritzbox Configuration

1.1. Setting up the Controlmini/-pro in the Fritzbox

1. Open the browser, enter „fritz.box" into the address bar and log in to your Fritzbox.
2. Navigate to Telephony -> Telephony Devices.
3. Go to „Configure new device", select the option „Telephone" in the next step and go to
„Next".
4.
Select „LAN/WLAN (IP telephone)", assign a meaningful name, e.g. „Controlmini" and
select „Next".
■
Enter the username and password for the Controlmini and note them for later
use. Be sure to give a secure password. This means it should not be the same as
the user name nor too short or too easy to guess. We recommend that you use an
automatically generated random password.
5.
Confirm the assigned phone number and select „Next".
6. Select „Accept calls for the following numbers only" and „Next".
7. You will get an overview, which you can confirm with „Apply". Press any button on the
Fritzbox to confirm the input for the router.

1.2. Setting up the wantec door intercom in the Fritzbox

8.
Under Telephony > Telephony Devices, go to „Configure new device" again and in the
next step select the option „Door Intercom System" and „Next".
9. The connection is made via „LAN/WLAN (IP door intercom)".
10. Assign a meaningful name for the door intercom and press „Next".
11.
Enter a username and password
■
Be sure to give a secure password. This means it should not be the same as the
user name nor too short or too easy to guess. We recommend that you use an
automatically generated random password.
12. For „Route doorbells to", select „Controlmini" from the drop-down list and go to
„Next".
■
If this option does not appear in the selection menu, you can also select „tele-
16
for the door intercom and note them down.
www.peaknx.com