Cresto W2 Bedienungsanleitung Seite 2

W2, W2T, W3.5
Index
1.0 Installation, Use, Compatibilty & Warning!
2.0 Introduction to W2, W2T, W3.5
3.0 Storage, Issue & Inspection
4.0 Quality, Legislation & Exclusions
5.0 Record Card
Description/Explanation of Symbols
Inspect the device, life line, hook and
anchorage for signs of wear, deforma-
tion, damage or corrosion.
Ensure hook swivels and twist gate
operate and close correctly.
Ensure load indicator has not de-
ployed.
Pull line sharply to engage brakes and
ensure device locks before each and
every use.
The device should be fitted above
the user.
Connect only to the Rear Dorsal "D"
ring of a fall Protection Full Body
Harness. Ensure that the hook of the
device is secure in the Harness "D"
Ring and that the gate of the hook
is locked.
The device will arrest a fall within 2
metres. Do not use the device at full
line pay out or in situations where
there is less than 3 metres
of ground clearance.
Max. capacity 140Kg.
This device must only be serviced by
a trained and competent individual.
Never attempt to service this unit or
tamper with its function in any way.
Install the device so that it is away
from the edge, so avoiding swing
hazards, the potential user must not
have to lean out to reach the
device or hook and endangering
themselves with a fall hazard.
Check for sharp edges & use edge
protection where required.
2
3
4
5
6
7